GEN3 PL1PH10 10 Amp 3 Pin Flat Rewireable Plug Top Standard AU Pins

Description

Rugged weatherproof power, standard flat pins.

The GEN3 PL1PH10 is a 10A single-phase industrial extension plug top with three standard flat pins and an IP66 weatherproof body. With a compression gland for quick rewiring, it's a tough replacement plug for leads and appliances that use a standard Australian 10A plug.

Key Features

• 10A single phase, 3 flat pins (standard Australian pattern)
• 250V AC
• IP66 rated — dust-tight and protected against powerful water jets
• Compression gland for quick cable termination (rewireable)
• Tough orange PCA18 virgin-grade plastic (no regrind)
• 316 stainless steel springs and screws
• Brass internal components (greater than 85% copper) for lower heat rise
• Operating temperature -25°C to +70°C
• Fits standard Australian flat-pin socket-outlets

Grab yours online for fast Australia-wide shipping.

Standard Pins, Industrial Build

The PL1PH10 uses the standard Australian three flat-pin pattern, so it fits standard 10A socket-outlets — but it's wrapped in a rugged IP66 weatherproof housing built for the worksite rather than the lounge room. That makes it a hard-wearing choice for outdoor leads, sheds and washdown areas where an ordinary domestic plug would not survive.

Built for Australian Conditions

IP66 protection means it is dust-tight and withstands powerful water jets from any direction. A virgin-grade PCA18 body, 316 stainless steel springs and screws, and brass contacts of greater than 85% copper (for lower heat rise) stand up to vibration, moisture and a wide -25°C to +70°C operating range.

Quick to Wire and Replace

A compression gland makes cable termination fast and secure, so it's a straightforward rewireable replacement plug top for a damaged or worn lead. It is interchangeable with other major brands and pairs with the matching GEN3 flat-pin extension socket and appliance inlet to build or repair a complete lead.

Q: Does the GEN3 PL1PH10 fit a standard Australian power point?
A: Yes. It uses the standard three flat-pin pattern, so it fits standard Australian 10A socket-outlets, in a rugged IP66 weatherproof housing.

Q: Is the GEN3 PL1PH10 weatherproof?
A: Yes. It is IP66 rated, meaning it is dust-tight and protected against powerful water jets, suitable for outdoor and industrial use.

Q: Can the GEN3 PL1PH10 be rewired?
A: Yes. It is a rewireable plug top with a compression gland for quick, secure cable termination, and should be wired by a licensed electrician.