CTL10-6 10mm Cable 6mm Stud Tinned Copper Tube Crimp Lugs

Description

10mm Cable. 6mm Stud. Tinned Copper. Compression Crimp Lug. Sold Individually.

The CTL10-6 is a 10mm tinned copper tube compression crimp lug with a 6mm stud hole — used to terminate a 10mm² conductor to a bolted connection point such as a terminal block, earth bar, busbar, or equipment stud. Annealed copper barrel with tin electroplated finish. Sold individually.

• CTL10-6 — 10mm Cable, 6mm Stud Tinned Copper Tube Crimp Lug
• Suits 10mm² conductor — 7/1.35 stranding
• 6mm stud hole — suits M6 bolts and studs
• Annealed copper barrel — tin electroplated finish for corrosion resistance
• Compression crimp barrel — single crimp
• For terminating conductor to terminal block, earth bar, busbar, or bolted connection
• Sold individually

Buy online now — fast dispatch Australia-wide.

Where the CTL10-6 Crimp Lug Is Used

A compression crimp lug terminates a single conductor end to a bolted connection point — the conductor is inserted into the barrel and a compression crimp tool closes the barrel around the conductor, making a permanent, mechanically secure, low-resistance termination. The tongue of the lug is then bolted to the connection point — a terminal block, earth bar, busbar, equipment stud, or similar — using an M6 bolt through the 6mm stud hole.

The CTL10-6 is sized for 10mm² conductor — a heavier cable size used in Australian commercial and light industrial electrical installations for sub-board feeds, larger air conditioning and mechanical plant circuits, and main circuit runs where current demand requires a conductor cross-section beyond the standard residential cable sizes. The 6mm stud hole suits M6 hardware — the most widely used bolt size for electrical connections in Australian switchboard, earthing, and equipment termination applications. The tinned copper construction combines the excellent conductivity of annealed copper with a tin electroplated surface that resists oxidation and maintains a clean, low-resistance contact at the bolted joint over the service life of the installation.

Crimp lugs in this range are available across a wide range of cable sizes and stud hole combinations — covering the full range of conductor sizes and connection hardware used in Australian electrical installations.

Q: What is the difference between a crimp lug and a crimp link?
A: A crimp lug (CTL10-6) terminates a single conductor to a bolted connection point — it has one barrel end for the conductor and one tongue with a stud hole for the bolt. A crimp link joins two conductor ends together — it has an open barrel at both ends. Use a crimp lug for conductor-to-terminal connections; use a crimp link for conductor-to-conductor joints.

Q: What stud or bolt size suits the CTL10-6?
A: The CTL10-6 has a 6mm stud hole, suited to M6 bolts and studs — the most widely used bolt size for electrical connections in Australian switchboard, earthing, and equipment termination applications.

Q: Is the CTL10-6 sold individually or in a bag?
A: The CTL10-6 is sold individually.