GEN3 S2P20 20A 2 Pole 500V Weatherproof Surface Switch IP66

Description

A rugged two-pole weatherproof isolating switch.

The GEN3 S2P20 is a 20A, 2-pole surface-mount switch rated 500V and IP66, built for outdoor, industrial and wash-down environments. As a two-pole switch it breaks both poles at once – active and neutral, or two phases – giving full isolation of the circuit it controls. The 20A rating suits higher-current loads than the 10A S2P10, while the 500V rating suits both single-phase isolation and switching within three-phase circuits. Moulded in the Series 56 style from durable PCA18 virgin-grade plastic, it stands up to dust, water and the demands of harsh sites.

Key Features

• 20A, 2-pole surface-mount switch
• 500V rated
• Switches both poles – full isolation (active and neutral, or two phases)
• IP66 weatherproof – dust-tight and protected against high-pressure water jets
• Series 56 style
• Surface mount
• Accepts cable from 1.5mm² to 6mm²
• Body approximately 109 × 101 × 109mm
• Durable PCA18 virgin-grade plastic (no regrind)
• 316 stainless steel springs and screws
• Brass internal components, greater than 85% copper
• Operating temperature −25°C to +70°C
• Australian/NZ approval or compliance certificates held

Get yours online for fast dispatch across Australia.

Two-Pole Isolation

The S2P20 switches two poles together, so it can isolate both the active and neutral of a single-phase circuit, or two phases of a larger supply, in one action. This full isolation is useful where equipment must be completely disconnected for safety or maintenance, rather than switching the active alone.

20A for Larger Loads

The 20A rating suits equipment drawing more than the 10A S2P10 can handle, while sharing the same two-pole switching and weatherproof build. It is a practical isolating switch for larger industrial circuits in exposed locations.

Built for the Outdoors

Rated IP66, the S2P20 is dust-tight and withstands high-pressure water jets, and operates across a −25°C to +70°C range. Moulded from PCA18 virgin-grade plastic with 316 stainless steel springs and screws and high-copper brass internals, it accepts cable from 1.5mm² to 6mm² and is built for long service in exposed and demanding locations, covered by Australian/NZ approval or compliance certificates.

Q: What does 2-pole mean on the GEN3 S2P20?
A: It switches two poles at once, isolating both the active and neutral of a single-phase circuit, or two phases of a larger supply, for full isolation.

Q: What is the difference between the S2P20 and the S2P10?
A: The current rating. The S2P20 is 20A and the S2P10 is 10A. Both are 2-pole 500V IP66 weatherproof surface switches.

Q: What cable size does the S2P20 accept?
A: It accepts cable from 1.5mm² up to 6mm².