32mm PVC Plain to Screwed Conduit Adaptor with Lock Nut Grey

Description

32mm. PVC. Grey. Plain to Screwed Conduit Adaptor with Locknut.

The Rylec PSA32C is a 32mm PVC plain-to-screwed conduit adaptor with locknut — the standard fitting for terminating a plain (unthreaded) 32mm rigid PVC conduit run into an enclosure, junction box, or any conduit entry with a standard threaded hole. The adaptor slides over the plain conduit end and the included locknut threads onto the screwed end from inside the enclosure to secure the conduit firmly at the entry point. Grey PVC construction to match standard grey conduit. Sold individually.

• Rylec — Series "PSA" PVC plain to screwed conduit adaptor
• 32mm — suits 32mm plain (unthreaded) rigid PVC conduit tube
• Grey PVC construction
• Includes locknut — for secure conduit retention at the entry point
• Threaded male end with locknut for enclosure/box entry
• Plain socket end accepts unthreaded rigid PVC conduit
• Sold individually

Order online now — fast dispatch Australia-wide.

Where the PSA32C Plain to Screwed Adaptor Fits

The PSA32C terminates 32mm plain rigid PVC conduit into enclosures, switchboards, and junction boxes. The 32mm size accommodates the larger conduit diameter used where higher cable counts or larger cable cross-sections require a bigger bore than 20mm or 25mm conduit can provide — common in sub-board conduit runs, commercial switchboard wiring, and multi-cable installations where conduit fill ratio requires the step up to 32mm.

Installation follows the same sequence as other PSA series adaptors: slide the adaptor over the conduit end (plain socket end first), pass the threaded end through the enclosure entry hole, then thread the locknut onto the screwed end from inside the enclosure and tighten to clamp the adaptor firmly against the enclosure wall. The conduit end is bonded to the adaptor socket using conduit cement on the plain socket side for a permanent, secure connection.

The PSA20C (20mm) and PSA25C (25mm) are available for smaller diameter conduit, and PSA40C (40mm) and PSA50C (50mm) for larger. All are Rylec grey PVC construction with locknut included.

Q: What is the difference between the PSA32C and a corrugated conduit fitting?
A: The PSA32C is for rigid plain (unthreaded) PVC conduit — it slides over the plain tube end and provides a threaded screwed enclosure entry. Corrugated conduit clip adaptors (CA-series) are for flexible corrugated conduit and clip onto the conduit corrugations. Use the PSA32C with rigid conduit only.

Q: Is the locknut included with the PSA32C?
A: Yes — the PSA32C is supplied complete with locknut for securing through the enclosure entry hole.

Q: When should I use 32mm conduit instead of 25mm?
A: Choose 32mm conduit when the cable count or individual cable sizes exceed what a 25mm conduit can comfortably accommodate. As a general guide, 32mm suits higher cable counts, larger individual cable cross-sections, or where a lower conduit fill ratio is required for easier cable pulling on longer conduit runs.

Warranty

This product is backed by an extended manufacturer warranty - click here for details.